• Operation Voltage - 24V AC/DC
• Maximum Operating Voltage - 250VAC
• Maximum Current - 8 AMP
• Minimum Switching - >50 mW
• Tolerance - -15% / +10%
• Protection - DLC Electronic Current Limiting Circuit Breaker
• Response Time - <20ms
• Temperature Rating - -20°C to +60°C   
• Protection Rating - IP20
• Approvals: BG, UL, CSA (depending on type)

* These are general specifications, please check individual data sheets for specific information

• DLC Electonic Current Limiting Circuit Breakers provide automatic reset with a fast response of 20mS, assuring that they meet requirements of Safety Category 4

• Some relays feature selectable Manual or Automatic Reset Function set with a dip switch on the back, to prevent access after installation
• Relays are designed to be used with   BTI non-contact switches as well as standard mechanical switches such as keyed safety interlocks and e-stops

Application

Part Number

List

Safety Category 4
For Monitoring Emergency Stop Buttons and Gate Switches

Our most popular relay
Designed for dual safety channel (Cat 4) applications
Easy to install:
1. Connect 24V (A1) & 0V    (A2)
2. Connect safety channel 1 between T11 & T12
3. Connect safety channel 2 between T21 & T22
4. Connect restart button (or jumper for automatic restart) between C & V.

The relay monitors the two safety circuits and will open the output contacts if either circuit is broken.

The relay checks that both circuits open at the same time, ensuring the switches are operating correctly.

When used with BTI non-contact switches the safety circuits are polarity depandant to guard against the possibility of short circuits

AWAX 26 XXL

$273.60

Safety Category 2 or 3
For Monitoring Emergency Stop Buttons and Gate Switches

The relay can either be Safety Category 2 or Safety Category 3, depending on how the inputs are wired.

If wired with 2 redundant inputs (as shown in the top drawing and described above), it would be Safety Category 3.

If wired with 1 input (as shown in the bottom drawing), it would be Safety Category 2.

Operating Voltage

24VAC/DC=

CO13XXL/24V

$254.30

Operating Voltage

85-265VAC=

CO13XXL/120-240V

$525.60

Safety Category 4
For Monitoring Emergency Stop Buttons and Gate Switches

for Two Independant Zones

Same operations as the AWAX 26XXL, but designed to control two independants safety circuits.

Featuring two seperate sets of indepandant redundant outputs.

AWAX 27 XXL

$561.60

Safety Category 4
For Monitoring Emergency Stop Buttons and Gate Switches

with High Operating Voltage  

Mutli-Function Safety Relay for Operating Voltages of

85 to 265 VAC.

AWAX45 XXL2/

120-240

$529.92

Safety Category 4
Zero Speed Controller

Monitors EMF from three phase motor to sense if movement has stopped.

Run in parallel, will not effect motor operation.

Outputs can be used to open locking style guards. Extra condition PNP outputs can be run to PLC.

Adjustable preset level and response time delay.

SPEED-TRONIC

$693.60

Safety Category 4
Time Delay Module

Provides 3 standard NC outputs, plus 2 NC / 1NO time delay outputs.

Time delay activated by a break in one or both safety channels.

Delay adjustable from 0 to 999 seconds.

EXEL-

TRONIC XXL

$660.00

Safety Category 3
Time Delay Module

This is a simple release delay time, with is activated by opening the NO contact. 

Delay adjustable from 0 to 999 seconds.

TIM-

TRONIC

XXL

$377.52

Safety Category 2
Extension Module

REL-

TRONIX

6SX

$134.40